Skip to main navigation menu Skip to main content Skip to site footer
Academia Open

Engineering

Vol 3 (2020): December

Analysis Of The Effect Of Alternator Modification On Himoinsa Genset 20 Kva To Load Testing And Cost
Analisa Pengaruh Modifikasi Alternator Pada Genset Himoinsa 20 kVA Terhadap Load Testing dan Cost



(*) Corresponding Author
DOI
https://doi.org/10.21070/acopen.3.2020.1197
Published
September 5, 2021

Abstract

A generator is a device or engine that generates electrical energy from the presence of mechanical energy obtained from a prime mover in the form of a diesel engine as the prime mover which then drives an AC generator or alternator, causing an electrical voltage. The aim of this research is that the generator can supply electricity needs at the Sumur Welut site by changing or modifying diameter of the wire on the alternator. This analysis includes the Stator and Rotor on the Alternator generator so that it can produce the electricity needed. From the test results, the load generated after being modified can supply power at the site but the fuel consumption is more wasteful, namely 0.9 liters / minute and also the generator temperature increases to 88.2 C. So that the radiator planning is done by changing the surface area of ​​the radiator from 2915 cm2 to 8077 cm2. Or change the radiator fan, which originally changed the wind speed of 4.7 m / s to 13 m / s.

 Keywords: Generator, Alternator, Load Testing, Radiator, Cost.

References

  1. Badaruddin dan F. Hardiansah, “ PERHITUNGAN OPTIMASI BAHAN BAKAR SOLAR PADA PEMAKAIAN GENERATOR SET DI BTS,” 791-1858-1-PB, vol. VI, no. 2, pp. 61-79, 2015.
  2. Desmiwarman dan V. R. Yandri, “PEMILIHAN TIPE GENERATOR YANG COCOK UNTUK PLTMH DESA GUO, KECAMATAN KURANJI, KOTA PADANG,” ipi284301, vol. IV, no. 5, pp. 25-28, 2015.
  3. Alfith, “Optimalsasi ATS (Automatic Transfer Switch) pada Genset (Generator Set) 2800 Watt Berbasis TDR,” 209-315-1-PB, vol. IV, no. 5, pp. 226-232, 2017.
  4. S. Bandri, “ANALISA PENGARUH PERUBAHAN BEBAN TERHADAP KARAKTERISTIK GENERTOR SINKRON,” ipi118822, vol. II, no. 1, pp. 42-48, 2013.
  5. n. ismail, m. dan I. lindra, “ANALISIS PERENCANAAN PEMBANGUNAN BTS (BASE TRANSCEIVER STATION) BERDASARKAN FAKTOR KELENGKUNGAN BUMI DAN DAERAH FRESNEL DI REGIONAL PROJECT SUMATERA BAGIAN SELATAN,” ISSN 1979-8911 , vol. 9, no. 5, p. 18, 2015.
  6. A. Goeritno, M. dan A. Hidayat, “STRUKTUR BELITAN STATOR DAN ROTOR BERMAGNET PERMANEN FLUKS RADIAL UNTUK ALTERNATOR FASE TUNGGAL,” 174634-ID-struktur-belitan-stator-dan-rotor-bermag, vol. XVI, no. 3, pp. 1-9, 2016.
  7. y. yunus, “Modifikasi Alternator Mobil Menjadi Generator 3 Fasa 220 V 600 RPM,” 10_Modifikasi_Alternator_Mobil_Menjadi_Generator_3_Fasa_220_V_600_RPM, vol. XII, no. 5, pp. 74-77, 2012.
  8. D. Septianto, Firdaus dan A. Hamzah, “Studi Perencanaan Pemasangan Genset Emergency Pada Gedung C Fakultas Teknik Universitas Riau,” 201192-studi-perencanaan-pemasangan-genset-emer, vol. III, no. 2, pp. 1-11, 2016.
  9. A. Lambajang, “ ANALISIS PERHITUNGAN BIAYA PRODUKSI MENGGUNAKAN METODE VARIABEL COSTING PT. TROPICA COCOPRIMA,” 1585-ID-analisis-perhitungan-biaya-produksi-menggunakan-metode-variabel-costing-pt-tropi, vol. I, no. 3, pp. 673-683, 2013.
  10. W. P. Widyaningsih, “PERUBAHAN JUMLAH ALUR KUMPARAN STATOR DAPAT MENINGKATKAN KAPASITAS DAYA KELUARAN GENERATOR SINKRON TIGA PHASA,” ipi443377, vol. IX, no. 1, pp. 24-28, 2013.
  11. A. Abdullah, “ANALISIS PERHITUNGAN BIAYA PRODUKSIBERDASARKAN METODE FULL COSTING,” B1C212038_sitedi_jurnal akmal, vol. II, no. 5, pp. 1-14, 2016.
  12. W. Sunarlik, “PRINSIP KERJA GENERATOR SINKRON,” Prinsip-Kerja-Geneator-Sinkron-, vol. III, no. 5, pp. 20-28, 2012.
  13. A. Sakura, “RANCANG BANGUN GENERATOR SEBAGAI SUMBER ENERGI LISTRIK NANOHIDRO,” Universitas Lampung, Bandar Lampung, 2017.

Downloads

Download data is not yet available.